Ribbon Cutting Calculator
Type the length of the ribbon, the length of each piece and, if you want it, the length lost at every cut, and you get how many whole pieces you can cut and what is left over. It works for ribbon, cord, tape, trim, rope or any roll you cut into equal lengths. Use the same unit for the three numbers: the page only prints the unit you pick next to the results and never converts anything behind your back. Everything is calculated in your browser.
Whole pieces you can cut
3
Pieces = floor((L + k) ÷ (s + k)); leftover = L − pieces × s − (pieces − 1) × k, where L is the total length, s the piece and k the loss per cut. Only the cuts between pieces are counted. The unit is a label: nothing is converted.
How it works
- Pick the unit you measure in, then type the total length of the ribbon.
- Type the length of one piece, in the same unit.
- Type the length lost at each cut, such as the width of a blade or a sealed end, or 0 if nothing is lost.
- Read the number of pieces and the leftover, then copy the summary.
What people use it for
Cutting gift ribbon
See how many 45 cm bows you can cut from a 1,000 cm spool before you buy a second one.
Cord and trim for a craft project
Check that a roll of cord gives the number of equal straps or ties your pattern needs, with the cut loss counted.
Tape and strips for a classroom or event
Work out how many name tags, wristbands or table runners come out of one roll and how much is left.
Questions
- How is the number of pieces calculated?
- n = floor((L + k) ÷ (s + k)), where L is the total length, s the length of a piece and k the length lost at each cut. It comes from the fact that n pieces need n × s + (n − 1) × k to fit, because there are n − 1 cuts between them. With L = 100, s = 30 and k = 1: (100 + 1) ÷ (30 + 1) = 3.26, so 3 pieces. With k = 0 it is simply floor(L ÷ s): 60 ÷ 30 gives 2 pieces and 59 ÷ 30 gives 1.
- How is the leftover calculated?
- Leftover = L − n × s − max(0, n − 1) × k. With L = 100, s = 30, k = 1 and 3 pieces it is 100 − 90 − 2 = 8. It counts only the n − 1 cuts between pieces: if you also cut the leftover off the last piece, that cut takes one more k out of the leftover. If the ribbon is shorter than one piece, there are 0 pieces and the leftover is the whole length.
- Which unit does it use?
- Whatever you pick, as long as the three numbers are in that unit: centimeters, meters, inches or feet. The unit only labels the results. The page does not convert between units, so do not type the ribbon in meters and the piece in centimeters. Decimals are read exactly: 0.3 divided into pieces of 0.1 gives 3 pieces, not 2.
- Which inputs are refused?
- The total length and the loss per cut can be 0 or more, up to 1,000,000,000,000. The piece must be above 0 and at least 0.000001. A combination that would give more than 1,000,000,000 pieces is refused, and a blank or negative number is refused with a message instead of a result. Numbers are read to 15 significant digits.