Bike Gear Speed Calculator
Type the number of teeth on the chainring and on the rear cog, your cadence in pedal turns per minute and the circumference of your wheel in millimetres, and you get the gear ratio, the distance covered in one turn of the pedals, the speed in kilometres and miles per hour and the gear inches. A short list gives indicative circumferences for common tyre sizes, and you can type your own. It assumes no slipping, no wind and no slope, runs in your browser, and sends nothing anywhere.
Speed at this cadence
35.5 km/h
Ratio = chainring ÷ cog; development = ratio × wheel circumference; speed = development × cadence × 60 ÷ 1,000 in km/h (÷ 1.609344 for mph); gear inches = wheel diameter in inches × ratio. The circumferences in the list are indicative values: the real one depends on the tyre, its pressure and the rider's weight, so roll your own wheel one turn and measure it for a precise figure. It assumes no slip and no wind or slope, and it does not say which gear to use.
How it works
- Type the teeth of the chainring and of the rear cog, as whole numbers.
- Type your cadence in pedal turns per minute.
- Pick a wheel and tyre size from the list, or type the circumference in millimetres.
- Read the ratio, the development, the speed and the gear inches, and copy the summary.
What people use it for
Comparing two gears
See that a 50/16 gear at 90 rpm gives about 35.5 km/h, then try 50/14 to see what a smaller cog adds.
Choosing a cassette
Try each cog at your usual cadence to see the speed it gives, and the gain for every 10 rpm.
Reading a gear in gear inches
Turn a chainring and cog pair into the gear inches figure used on many gear charts.
Questions
- How are the ratio, the speed and the gear inches calculated?
- Ratio = chainring teeth ÷ cog teeth, development = ratio × wheel circumference, speed in km/h = development in metres × cadence × 60 ÷ 1,000, and mph = km/h ÷ 1.609344. Gear inches = wheel diameter in inches × ratio, with the diameter taken as circumference ÷ π. For 50/16 with a 2,105 mm wheel at 90 rpm: ratio 3.125, development 6.578 m, 35.5 km/h, 22.1 mph and about 82.4 gear inches.
- Where do the wheel circumferences come from?
- The list gives rounded, indicative figures for 700×25c (2,105 mm), 700×28c (2,136 mm) and 26×1.95 (2,050 mm). The real circumference depends on the exact tyre, its pressure and the load, so for a precise result mark the tyre on the ground, roll the wheel one turn with your weight on the bike and measure the distance, then type it in millimetres.
- Which values are refused?
- Chainring and cog teeth must be whole numbers from 1 to 200, the cadence must be above 0 and up to 300 rpm, and the circumference must be between 100 and 10,000 mm. A fraction of a tooth, a zero, a negative number or text gives a message instead of a result.
- What does the page not take into account?
- Speed is the theoretical speed at a steady cadence: it ignores slip, the wind, the slope, the rolling resistance and the limits of your legs. It does not say which gear to choose or what cadence is good for you. Use it to compare gears with each other, not to predict an exact speed on the road.