Skip to content

Container Fill Time Calculator

Enter the volume of a container in litres and the flow in litres per minute, and you get the time to fill it in minutes and as hours, minutes and seconds. Switch to the other mode to type how many minutes you can spare and get the flow you need. You can also enter a number of identical containers filled one after the other, for example 12 jerry cans or 6 barrels. It only divides the numbers you give it, assumes the flow stays the same, and nothing is sent anywhere.

Time to fill

4 min

That is 4 min for 20 litres at 5 litres per minute.
Time for one container (minutes)
4
Total volume (litres)
20

Time = total litres ÷ flow. It assumes the flow stays the same and counts no time to swap containers; a tap or pump often slows down as a tank fills.

How it works

  1. Choose whether you want the time to fill or the flow needed.
  2. Enter the volume of one container in litres, and the number of identical containers if there are several.
  3. Type the flow in litres per minute, or the number of minutes you have, depending on the mode.
  4. Read the time or the flow, then copy the summary.

What people use it for

  • Filling a water butt or a barrel

    See that 200 litres at 8 litres per minute take exactly 25 minutes.

  • Planning a run of identical cans

    Enter 12 cans of 20 litres at 5 litres per minute and read the time per can and the total time for all of them.

  • Finding the flow for a deadline

    Type 90 litres and 15 minutes to see that you need 6 litres per minute.

Questions

How are the time and the flow calculated?
Time in minutes = total litres ÷ flow in litres per minute, and the flow needed = total litres ÷ minutes. 20 litres at 5 litres per minute take 4 minutes, 15 litres at 3 take 5, and 9 litres at 1.5 take 6. With several containers the total litres are the volume of one multiplied by their number, filled one after the other at the same flow, and the page also shows the time for a single container.
Is the flow really constant while a container fills?
The page assumes so, because it only divides. A tap, a pump or a hose often slows down as a tank fills or as the pressure changes, and the time to swap containers is not counted. Measure your own flow by timing a known volume if you need a reliable figure, and treat the result as an estimate.
Which values are refused?
The volume must be 0 or more and up to 1,000,000,000,000 litres, the flow above 0 and up to 1,000,000,000,000 litres per minute, the target time above 0 and up to 1,000,000,000 minutes, and the number of containers a whole number from 1 to 1,000,000. A result longer than 1,000,000,000,000 minutes is refused rather than displayed, and a nonzero value below 0.000000001 is refused so nothing appears as a misleading zero.
Can I use gallons, millilitres or another unit?
The page speaks in litres per minute, but the arithmetic is the same in any unit if you use it consistently: gallons with gallons per minute give minutes, and the flow needed comes out in the unit you typed per minute. The labels still say litres, so convert first if you want them to match.