Skip to content

Occupancy Target Calculator

Give the capacity of a room or a venue, the number of people there now and the occupancy you aim for. The calculator tells you how many more can come in, or how many too many are inside. A table of time slots compares each one with the same target and points out the busiest.

To do

Admit 30 more

Target 50 % of 100 = 50 people, 20 present (20 %). You can admit 30 more.

Occupancy by slot: target 50 people, 4 slots, 1 above target. Tightest: 12:00 with 63 present (63 %).

SlotPresentOccupancyGap to targetAction
9:001818 %+32Admit 32
10:003232 %+18Admit 18
11:004141 %+9Admit 9
12:006363 %-1313 too many

How it works

  1. Enter the capacity and the number of people present now.
  2. Enter the target occupancy as a percentage, from 0 to 100.
  3. Read how many to admit or how many are over the target.
  4. Optionally list your time slots as “slot ; present” to compare them, then copy the summary or the CSV.

What people use it for

  • Shops, gyms and cafés

    Decide at the door how many more people can enter while staying under the level you set.

  • Classrooms and meeting rooms

    Plan a room at 70 % of its seats and see how many places are left.

  • Event shifts

    Compare the headcount of each hour with the target and find the tightest one.

Questions

How is the number to admit computed?
The goal is the capacity times the target divided by 100, rounded down to a whole person, so the target is never exceeded by a fraction of a person: 33.33 % of 100 is 33.33, shown as 33 people (33.33 rounded down). The number to admit is the goal minus the people present. If the result is negative, that many people are over the target and should leave.
Is the target a legal limit?
No. The tool only does the arithmetic on the numbers you enter. Legal or safety limits for a venue depend on its type and on local rules, so check them with the authority or the building owner before you rely on a figure.
What counts as the tightest slot?
The slot with the most people present. If several slots have the same headcount, the first one in your list is named. Every slot uses the capacity and target above, so its gap is the goal minus its own headcount.
What happens with zero or invalid values?
A capacity of 0 gives a goal of 0 and no percentage, since there is nothing to divide by. A target above 100 or below 0 is refused with a message, and so is a capacity or a headcount that is not a whole number; the target itself may have up to two decimals. If more people are present than the capacity, the tool still computes the surplus.