Skip to content

Ohm's Law Calculator

Pick the two quantities you know among voltage, current, resistance and power, enter them with their units, and get the other two with the formula and the numbers shown step by step. Milli, kilo and mega prefixes are supported, and a warning appears when a result cannot be real.

Resistance and power

480 Ω · 300 mW

Voltage (V) · given
12 V
Current (I) · given
25 mA
Resistance (R)
480 Ω
Power (P)
300 mW
  • R = V ÷ I = 12 V ÷ 25 mA = 480 Ω
  • P = V × I = 12 V × 25 mA = 300 mW

How it works

  1. Choose which two quantities you know, such as voltage and current.
  2. Enter each value and pick its unit prefix: milli, none, kilo or mega.
  3. Read the other two quantities and the formulas used.
  4. Check any warning, then copy the summary.

What people use it for

  • Choosing a resistor

    Find the resistance that limits an LED or a sensor to the current you want from a given supply.

  • Checking power

    See how many watts a resistor dissipates and whether a 0.25 W part is enough.

  • Sizing a load

    From a power rating and a supply voltage, find the current a device draws and its resistance.

Questions

Which formulas are used?
Ohm's law V = I × R and the power law P = V × I. From those: R = V ÷ I, P = V² ÷ R = I² × R, I = P ÷ V, R = V² ÷ P = P ÷ I², V = P ÷ I, I = √(P ÷ R) and V = √(P × R). Each result shows the formula with your numbers substituted.
Which units can I use?
Volts (V), amperes (A), ohms (Ω) and watts (W), each with a milli (m), kilo (k) or mega (M) prefix. Results are shown with 4 significant digits and the nearest prefix from pico to giga, so 0.025 A appears as 25 mA.
When does the tool show a warning?
When any of the four quantities is zero, negative or undefined (a division by zero, or a square root of a negative number). In this model of a resistor, all four are above zero, so a warning usually means a typo or a wrong sign. The numbers are still shown so you can see what happened.
What are the limits?
It covers a resistor in a DC circuit, or the RMS values of an AC circuit with purely resistive load. For reactive loads with a coil or a capacitor, the power factor and impedance change the result. The numbers are not rounded to standard resistor values.