Battery Charge Time Calculator
Enter the capacity of the battery in watt-hours, the level you start from and the level you want, the power of the charger in watts and its efficiency, and get the time needed, the energy that goes into the battery and the energy drawn from the charger. It works for a phone, a laptop, a power bank, an e-bike or a car battery as long as you know the capacity in Wh. The result is an ideal-case estimate with a constant charging power: real chargers slow down as the battery fills, especially above 80 percent.
Estimated charging time
3 h 20 min
Time = capacity × (target − start) ÷ 100 ÷ (charger power × efficiency). This is an ideal estimate at constant power: real batteries slow down as they fill, especially from 80 to 100 percent, so expect more. Efficiency of 90% used.
How it works
- Type the battery capacity in Wh. If you only know volts and amp-hours, multiply them: 12 V × 50 Ah = 600 Wh.
- Set the starting level and the target level in percent.
- Enter the charger power in watts and its efficiency, as 0.9 or 90%. Use 1 if you want to ignore losses.
- Read the time, the energy stored and the energy drawn, then try another charger or a lower target level.
What people use it for
Choosing a charger
Compare how long a 30 W and a 65 W charger need to bring the same laptop from 10 to 80 percent.
Planning an overnight charge
Check that an e-bike or a power station will be full before you need it, with a realistic efficiency of 85 to 90 percent.
Sizing a solar or generator charge
Find how many hours a small source needs to refill a battery, and how much more energy it must supply than the battery stores.
Questions
- What formula does the calculator use?
- Energy stored = capacity × (target − start) ÷ 100. Energy drawn from the charger = energy stored ÷ efficiency. Time in hours = energy drawn ÷ charger power. For a 500 Wh battery from 20 to 80 percent with a 100 W charger at an efficiency of 1, that is 500 × 60 ÷ 100 = 300 Wh, so 3 hours. With a 1,000 Wh battery from 0 to 100 percent, a 200 W charger and an efficiency of 0.8, it is 1,000 ÷ (200 × 0.8) = 6.25 hours, or 6 h 15 min.
- Why will my real charge take longer?
- The formula assumes the charger delivers its full power all the time. Lithium batteries charge fast at first and then reduce the current as they approach full, so the last 20 percent often takes as long as the first 80 percent. A phone or a laptop may also limit the power it accepts, use some of it to run the screen, or warm up and slow down. Treat the result as the best case and add a margin.
- What efficiency should I enter?
- Efficiency is the share of the energy taken from the charger that ends up in the battery; the rest is heat. Values around 0.85 to 0.95 (85 to 95 percent) are common for good chargers, and lower for a cheap charger, an inverter or a cold battery. You can type 0.9, 90 or 90%: a value of 1 or less is read as a fraction, a value above 1 as a percent. Enter 1 to get the time with no losses.
- What does the page refuse?
- A capacity, charger power or efficiency of 0 or less, an efficiency above 100 percent, levels outside 0 to 100, and a target level below the starting level, since this tool only charges. A target equal to the start gives 0 minutes. Capacity is limited to 10,000,000 Wh and the charger to 1,000,000 W. The numbers never leave your browser.